Cambridge IGCSE Physics 0625/52 October/November 2025 (Paper 5 Practical Test): Question-by-Question Guide
Past Papers

Cambridge IGCSE Physics 0625/52 October/November 2025 (Paper 5 Practical Test): Question-by-Question Guide

Mahira Kitchil Project Head, Tutopiya
• 8 min read
Updated

Cambridge IGCSE Physics 0625/52 is the October/November 2025 Paper 5 (Practical Test), variant 2. It lasts 1 hour 15 minutes, is worth 40 marks and is sat by Core and Extended candidates whose school enters them for the practical test rather than Paper 6. It had four compulsory questions: three experiments worth 11 marks each and a 7-mark plan. This guide goes through the paper question by question and shows what the official mark scheme gave marks for. The paper and its mark scheme are free on the Tutopiya Learning Portal.

For the newest series of the same paper, see 0625 Paper 52 May/June 2026: questions and mark scheme.

Paper 5 and Paper 6 share their contexts. The same four investigations appear on 0625/62 (Alternative to Practical), where the readings are printed for you. Work through both for double the practice on the same skills.

For an overview of all six 0625 papers from this series, see IGCSE Physics 0625 Oct/Nov 2025 Papers: Topics & Mark Scheme.

0625/52 at a glance

Paper codes: the code printed on the cover is 0625/52/O/N/25, the question paper file is 0625_w25_qp_52 and the mark scheme file is 0625_w25_ms_52.

QuestionTopicMarksMain command word
1Ray trace: reflection in a plane mirror at 10°, 20° and 30°, ratio r = a/b11Draw, measure
2Unknown resistor Z: voltmeter readings, current, graph of V against I, gradient11Record, plot
3Cooling of hot water in a beaker: readings, rates of cooling, estimates11Record, calculate
4Plan: what affects the height a ball reaches on a flexible track7Plan
Total40

Question-by-question walkthrough

Question 1: reflection by a plane mirror (11 marks)

You drew a mirror line LN with mid-point M, a parallel line PR 12.0 cm below it and a normal from M down to PR (meeting it at Q). A ray at angle θ to the normal was reflected, and the reflected ray met PR at T.

  • The construction (1 mark): the normal drawn correctly by eye, extended to the bottom of the page, with PR present.
  • The incident line at θ = 10° (1 mark): within 1° and labelled O.
  • The reflected ray (1 mark): drawn through your two crosses.
  • Lengths a = QT and b = MT (1 mark): both recorded to the nearest millimetre.
  • Ratio r = a ÷ b (2 marks): one mark for the calculation and one for giving it to 2 significant figures.
  • Repeat for 20° and 30° (1 mark): a full set of results in the table.
  • Is r directly proportional to θ? (2 marks): one mark for a statement that matches your results (the scheme expected yes) and one for using values from the table, such as showing that r ÷ θ is roughly constant.
  • More confidence in the answer (1 mark): extend the investigation to more values of θ.
  • A source of inaccuracy (1 mark): for example the reflecting surface is at the back of the mirror (its thickness), the width of the light ray or difficulty finding its centre, a room that is not dark enough, or small errors in the protractor angle having a large effect on a and b.

Question 2: finding the resistance of Z (11 marks)

The circuit had a supply, resistor Z and a switch, with a gap between X and Y and a voltmeter across the gap. You read the voltmeter with the gap open (V₀), then with resistors of 10, 22, 39, 47 and 68 Ω in the gap.

  • V₀ (1 mark): recorded to 0.1 V or better.
  • V with 10 Ω (1 mark): present and less than V₀.
  • The other readings (2 marks): one for all values present, one for V increasing as R increases.
  • Current I = V ÷ R (2 marks): one for correct values and one for all values to 2 significant figures.
  • Graph of V against I from the origin (3 marks): suitable scales filling at least half the grid, plots correct to half a small square, and a thin, continuous best-fit line.
  • Gradient G (1 mark): show the triangle on the graph and calculate Δy ÷ Δx, using at least half the distance between the end plots. The line slopes downwards, because V falls as more current flows through Z.
  • R_Z to the nearest ohm (1 mark): the gradient’s size is the resistance of Z. Any whole number from 19 Ω to 25 Ω scored.

Question 3: cooling of hot water (11 marks)

  • Room temperature (1 mark): to the nearest 0.5 °C.
  • Six temperatures from 0 to 5 minutes (2 marks): one for all recorded and one for them decreasing.
  • Why wait 30 s first (1 mark): to let the thermometer reach the temperature of the water (or respond, or let the beaker warm up), so that the reading has stopped rising.
  • How to read the thermometer accurately (1 mark): read it at eye level, perpendicular to the scale; keep the thermometer off the sides and base of the beaker; stir before each reading; or hold the stopwatch close to the thermometer.
  • Fall in temperature over the first two minutes (1 mark) and rate R₁ = fall ÷ time (1 mark), in °C/min.
  • Rate R₂ over the last two minutes (1 mark): correct, and smaller than R₁.
  • Conclusion (1 mark): the rate of cooling decreases as the water cools.
  • Temperature after a further 5 minutes (1 mark): any estimate where the fall over those 5 minutes is smaller than the fall in the first 5 minutes.
  • Temperature after a further 50 minutes (1 mark): room temperature, the value you recorded at the start.

Question 4: planning the flexible track experiment (7 marks)

A ball rolls from rest down one side of a flexible track, up the other side and stops for a moment at height h. You planned how one variable affects h. The mark scheme used seven marking points:

  1. Variable: a valid variable that could affect h, clearly stated.
  2. Apparatus: a ruler or measuring tape, plus whatever measures your variable (not needed if your variable is the release height or the ball’s diameter, which the ruler covers).
  3. Method, part 1: measure the independent variable and release the ball.
  4. Method, part 2: measure h and repeat for a new value of the variable. Both halves are needed.
  5. Control variable: any significant variable suited to your choice.
  6. Table: columns for the independent variable and h, with units in the headings.
  7. Conclusion: compare the readings to see whether and how h changes with the variable, or plot a line graph with the axes named.

Where the marks are on 0625/52

  • Taking and recording readings carried 9 of the 40 marks: a and b with the full set of results in Question 1, the voltmeter readings in Question 2, and room temperature and the six water temperatures in Question 3.
  • Drawing the ray trace carried 3 marks, all for careful construction with a ruler and protractor.
  • Calculations carried 7 marks: the ratio r, the currents, and the temperature fall and two cooling rates. Two of them had a separate mark for 2 significant figures.
  • Graph work carried 5 marks: plotting (3), the gradient (1) and R_Z within the accepted range (1).
  • Conclusions, evaluation and technique carried 9 marks, all 1 or 2 marks each: proportionality, confidence, inaccuracy, the 30 s wait, thermometer technique, the cooling conclusion and the two estimates.
  • The plan carried 7 marks, the single biggest block, and it needs no apparatus to practise.

How to self-mark 0625/52 with the mark scheme

  1. Mark against your own readings. Calculations and conclusions follow from your values, so check each step against your numbers, not the expected ones.
  2. Check the precision of every reading. Lengths to the nearest millimetre, V₀ to 0.1 V or better, and room temperature to the nearest 0.5 °C.
  3. Look for the trend marks. Question 2 gave a mark for V increasing, and Question 3 gave marks for temperatures decreasing and for R₂ being smaller than R₁. Readings that break the trend lose those marks.
  4. Count significant figures where asked. The ratio r and the currents each had a separate 2 significant figure mark.
  5. Mark your graph strictly: scales filling at least half the grid, every plot within half a small square, a thin line, and a large gradient triangle shown on the graph.
  6. Mark the plan against the seven points, ticking only what you stated explicitly.

Sit 0625/52 as a timed mock

The real paper needs the apparatus, so if you have no lab access, do the full timed mock on 0625/62 and use this paper for Question 4 and the analysis steps. In a school lab, a workable plan for 75 minutes is:

BlockMarksTime
Question 11120 minutes
Question 21120 minutes
Question 3 (includes 5 minutes of cooling)1118 minutes
Question 4712 minutes
Check, especially units and significant figures–5 minutes

Draft the Question 4 plan while the water cools in Question 3, but keep the stopwatch in view so you do not miss a reading.

0625/52 in other series

Both papers had three 11-mark experiments and a 7-mark plan, and both included a circuit with an unknown resistor found from a graph’s gradient, a thermal experiment with a rate in °C/min, and a plan built around a metal ball. In May/June 2026 the resistor graph was 1/V against R and the plan timed a ball falling through oil; here it was V against I and the height a ball reaches on a track. The mirror ray trace was new to this paper.

Other October/November 2025 0625 papers

Practise and download

Need help with a 0625 topic? Book a free trial lesson with an IGCSE Physics tutor →

Frequently asked questions

What experiments were on 0625 Paper 52 October/November 2025? +

Four tasks: a ray trace of reflection in a plane mirror, a circuit to find the resistance of an unknown resistor Z from a graph of V against I, the cooling of hot water in a beaker, and a plan for how one variable affects the height a metal ball reaches on a flexible track.

How many marks is 0625/52 and how long is it? +

It is out of 40 marks and lasts 1 hour 15 minutes. Questions 1, 2 and 3 are worth 11 marks each and the planning question is worth 7.

What was the resistance of Z in 0625/52 Oct/Nov 2025? +

The gradient of the V against I graph gives the resistance of Z, recorded to the nearest ohm. The mark scheme accepted any whole number from 19 Ω to 25 Ω.

Was r directly proportional to the angle in 0625/52 2025? +

The mark scheme expected students to agree. The mark was for a statement that matched your own results, plus a second mark for using values from your table to justify it, for example by showing that r divided by the angle stays about the same.

Who sits 0625/52 instead of Paper 6? +

Core and Extended candidates whose school enters them for the practical test. Paper 6 (Alternative to Practical) is the written alternative and used the same four investigations in October/November 2025.

Where can I download 0625/52 October/November 2025 and its mark scheme? +

Both are free to download and print on the Tutopiya Learning Portal, on the Cambridge IGCSE Physics 0625 past papers page.

What is 0625_w25_qp_52? +

0625_w25_qp_52 is the file name of the question paper for Cambridge IGCSE Physics 0625 Paper 52 (Paper 5 Practical Test, variant 2), October/November 2025. Its mark scheme is 0625_w25_ms_52, and the code printed on the cover is 0625/52/O/N/25. In these file names, w25 means the October/November 2025 series, qp means question paper and ms means mark scheme.

Ready to Excel in Your Studies?

Get personalised help from Tutopiya's expert tutors. Whether it's IGCSE, IB, A-Levels, or any other curriculum — we match you with the perfect tutor and your first session is free.

Book Your Free Trial
M

Written by

Mahira Kitchil

Connect on LinkedIn →

Project Head, Tutopiya

Mahira Kitchil is a Project Head at Tutopiya, where she works with Cambridge IGCSE and Edexcel A-Level teachers in more than 20 countries on how exams are set and marked. She writes practical guides that help students find the right past papers and use the mark scheme the way examiners do, so every practice paper counts.

Mahira Kitchil on LinkedIn

Get Started

Courses

Company

Subjects & Curriculums

Resources

Book a Tutor

Struggling with this topic?

Practise IGCSE Physics with free topic quizzes