Vernier caliper for the hole in a steel washer
A student plans to find the volume of a steel washer. The washer has an outer diameter of about 24 mm and a central hole of diameter about 8 mm.
(a) State the resolution of a vernier caliper. (1)
(b) Give one reason why the student should use a vernier caliper rather than a micrometer screw gauge to measure the diameter of the hole. (1)
- 1
(a) 0.1 mm (accept 0.01 cm) (1)
- 2
(b) A vernier caliper has inside (internal) jaws that can be opened against the sides of the hole, whereas the anvil and spindle of a micrometer can only measure an external dimension (1)
- 3
Not credited. "A vernier is more accurate" (it is not: the micrometer has the finer resolution, 0.01 mm) or "easier to use" with no reason. The reason must refer to measuring an internal diameter.
Answer
(a) 0.1 mm. (b) The vernier caliper has inside jaws that fit into the hole; a micrometer can only measure external dimensions.
Examiner tip
Learn the two resolutions the specification names: vernier caliper 0.1 mm, micrometer screw gauge 0.01 mm. A resolution with no unit earns nothing. In (b) the micrometer is the better instrument for resolution, so the only valid reason is the practical one: it cannot reach inside a hole.