Field of long straight wire
State the formula for the magnetic flux density at distance from a long straight wire carrying current .
- 1
Answer
. .
Examiner tip
Falls as (NOT ). Direction: concentric circles around wire (right-hand grip rule).
Launching your learning experience…
Cambridge International AS & A Levels Physics 9702 · Standard · Syllabus 2025-2027
Exam-style 9702 practice on the magnetic field produced by currents: long straight wire (), flat circular coil (), long solenoid (). Items span definitions (Foundation), direct field calculations (Standard), and net fields from multi-wire geometries (Challenge). Syllabus 20.4 (2025–2027).
This page has 10 exam-style A Level Physics 9702 magnetic fields due to currents worked examples — 3 Foundation, 4 Standard and 3 Challenge. Each one shows the full method step by step, the final answer in the form a marker expects, and an examiner tip on where marks are commonly lost.
State the formula for the magnetic flux density at distance from a long straight wire carrying current .
Answer
. .
Examiner tip
Falls as (NOT ). Direction: concentric circles around wire (right-hand grip rule).
State the formula for the field at the centre of a flat circular coil of turns, radius , carrying current .
Answer
.
Examiner tip
For a single loop (): at centre. Direction perpendicular to coil's plane (right-hand rule).
State the formula for the field inside a long solenoid of turns per metre, carrying current .
Answer
(uniform inside).
Examiner tip
Independent of position inside (uniform field). is turns per METRE, not total turns.
Find the field at from a long straight wire carrying .
Answer
(32 μT, comparable to Earth's field!).
Examiner tip
Household wires at normal operating currents can generate fields comparable to Earth's — detectable by sensitive compasses.
A flat circular coil of 100 turns, radius , carries . Find the field at the centre.
Answer
.
Examiner tip
Multi-turn coils give much larger fields than single wires for the same current.
A -long solenoid has 1000 turns and carries .
(a) Find (turns per metre).
(b) Find inside.
(c) State what happens if iron core is inserted.
(a)
(b)
(c) Iron core: increases by factor (relative permeability, typically ~1000 for soft iron). increases ~1000-fold.
Answer
(a) m⁻¹. (b) . (c) Iron core: ~1000× stronger.
Examiner tip
Electromagnets use iron cores to amplify field. For high-field magnets (MRI, particle accelerators), superconducting coils with no iron core are used — can reach ~10 T.
Two parallel wires apart carry each in the same direction (both out of page). Find the field at the midpoint between them.
At the midpoint, distance from each wire is .
Each wire produces field (right-hand rule): wire 1 (left, current out of page) → field at midpoint = DOWN. Wire 2 (right, current out of page) → field at midpoint = UP. They OPPOSE.
Opposite directions cancel.
Answer
at midpoint (two equal currents in same direction).
Examiner tip
If currents were ANTIPARALLEL, fields would ADD at midpoint — T. Always sketch field directions carefully.
A long straight wire runs through the centre of a flat circular coil (both coplanar is impossible — assume wire perpendicular to coil's plane, passing through its centre). Wire current , coil of 50 turns radius carries . Find the field at the coil's centre.
At the coil's centre (through which the wire passes), the field from the wire is ambiguous (singular at ). Assume we're a very small distance from the wire — the wire's field at a 'test point' very near the centre is enormous, but it points in the plane of the coil (perpendicular to the wire). Coil's field is perpendicular to its plane (along the wire).
They are PERPENDICULAR vectors. Realistic question: give only the coil's contribution.
Answer
along the wire's direction (perpendicular to coil's plane). Wire's own field is undefined at .
Examiner tip
Realistic exam Q would specify a point AT A SMALL OFFSET from the wire. The two fields are perpendicular — vector addition.
(a) State the condition for the formula to apply inside a solenoid.
(b) State what happens at the ENDS of a real (finite) solenoid.
(c) State approximate value of at the end.
(a) Solenoid must be 'long' — i.e., length much greater than diameter. Formula applies near the middle.
(b) At the ends: field is HALF of the central value. Pattern spreads out — field lines diverge like a bar magnet's.
(c)
Answer
(a) L >> D. (b) At ends: B is half of central value; field spreads. (c) .
Examiner tip
Realistic solenoids are not infinite. For precision work, use Helmholtz coils (two coaxial loops) for a more uniform central region.
A long straight wire above the ground carries current horizontally east. Earth's horizontal magnetic field is , pointing north. Find the current (and direction) needed to cancel Earth's field directly below the wire.
Directly below the wire (0.10 m below), Earth's field is north. We need the wire's field to point SOUTH there.
By right-hand rule: wire carrying current EAST produces, below itself, field pointing NORTH (circles around wire in CCW direction viewed from east). For field pointing SOUTH below, current must be WEST.
Set magnitudes equal.
Answer
flowing WEST.
Examiner tip
A real-world application: 'magnetic noise cancellation' — AC current loops near sensitive instruments can cancel ambient fields. Used in some high-precision labs.
These worked examples are written by Tutopiya to cover the same syllabus content as the official Cambridge International AS & A Levels 9702 specification (2025-2027). They are exam-style questions, not reproductions of past paper questions.