Drawing a back-to-back stem-and-leaf diagram
A gardener grows seedlings using two fertilisers, and . After three weeks the height of each seedling is measured, in cm, correct to 1 decimal place.
Fertiliser (11 seedlings):
Fertiliser (15 seedlings):
(a) Represent the data by a back-to-back stem-and-leaf diagram with fertiliser on the left-hand side.
(b) Find the median and the interquartile range of the heights for fertiliser .
- 1
The data are to 1 decimal place, so the stems are the units ( to ) and the leaves are the tenths. Write each stem once, in increasing order down the page, covering both data sets.
- 2
Order fertiliser first. On the left of a back-to-back diagram the leaves increase from right to left, moving away from the stem, so the smallest leaf sits next to the stem.
- 3
Order fertiliser and write its leaves on the right, increasing from left to right. Keep the leaves in neat vertical columns and do not use commas.
- 4
Write a key that reads both sides, uses different leaves on each side so it cannot be misread, and gives the units. For example: means cm for and cm for .
Model answer for (a) - 5
For (b), has values. With the convention the lower quartile, median and upper quartile are the 4th, 8th and 12th values.
- 6
Read these from the ordered list (or count leaves on the diagram) and label the median.
- 7
The interquartile range is the upper quartile minus the lower quartile.
Answer
(a) See diagram: stems 3–7, leaves on the left (right to left), leaves on the right, key means cm for and cm for . (b) Median cm, IQR cm
Examiner tip
Each part of the diagram carries its own mark: the stems, each side's leaves (ordered, aligned, no commas) and a key for both sides with units. A symmetrical key such as does not show which side is which, and a key saying "48" instead of "4.8 cm" misreads decimal data. Drawing two separate diagrams is capped, so always put both groups on one shared stem.