Variables. Independent variable: time of heating with acid — 0, 2, 4, 6, 8 and 10 minutes. Dependent variable: concentration of reducing sugar produced, estimated with Benedict's solution against colour standards.
Hydrolysis. For each time, put 2.0 cm³ of 1.0% sucrose solution in a tube with 1.0 cm³ of dilute hydrochloric acid (same concentration each time). Heat in a boiling water bath (about 95 °C, checked with a thermometer) for the set time, then immediately cool the tube in iced water to stop further hydrolysis.
Neutralise. Add 1.0 cm³ of sodium hydrogencarbonate solution and test with pH paper, adding a little solid if needed until effervescence stops and the pH is 7–8, so that every tube is at the same pH and the same dilution before Benedict's is added.
Benedict's test. Add 2.0 cm³ of Benedict's solution (in excess) to each tube and heat at 90 °C for exactly 5 minutes in the same water bath.
Colour standards. Make glucose standards of 0, 0.2, 0.4, 0.6, 0.8 and 1.0%. Put 2.0 cm³ of each in a tube and add the same 1.0 cm³ of acid and 1.0 cm³ of neutraliser, so that the standards are diluted exactly as the samples were, then heat with Benedict's in the same way. Match the colour of each sample against the standards on a white background to estimate its reducing sugar concentration.
Controls and replicates. Control: sucrose heated for 10 minutes with 1.0 cm³ distilled water instead of acid — should stay blue, showing the acid causes hydrolysis. Carry out three replicates for each time and use the modal/mean estimate.
Risk. Dilute HCl and Benedict's solution are irritants — wear eye protection; hot water bath can scald — use tongs. Low risk overall.